Programming the Auto-lock Feature Using the Instrument Cluster Message Center
NOTE:
The auto-lock feature can be activated or deactivated independently of the auto-unlock feature.
NOTE:
The auto-lock feature of the SJB can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to MODULE CONFIGURATION
article.
- With all the vehicle doors closed, turn the ignition key from the OFF to the ON position.
- Press the SETUP button on the message center switch until AUTO-LOCK <ON> OFF is displayed.
- Press the RESET button to select ON or OFF. If the auto-locks are enabled, the message center will have brackets around the <ON> display. If the auto-locks are disabled, the message center will have brackets around the <OFF> display.