Torca® Clamp
- Remove the nut from the Torca® clamp.
- Grind the spot weld from the Torca® clamp and remove the clamp.
- Clean the uneven surface area and position a Torca® clamp.
- Make sure the back of the slot is covered by the clamp and the button is fully seated inside the notch.
- Tighten the Torca® clamp.
- Tighten to 47 Nm (35 lb-ft).
NOTE:
Make sure the clamp position is no more than 27.5 mm (1.08 in) or less than 25.5 mm (1 in) from the inlet of the resonator pipe.
Fig 2: Making Sure Back Of Slot Is Covered By Clamp & Button Is Fully Seated Inside Notch With Specifications
NOTE:
Do not tighten the clamp until the exhaust system has been aligned.