LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2009 >> Edge SE, AWD >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> Four Wheel Drive (4WD) System DTCS
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Four Wheel Drive (4WD) System DTCS

4X4 CONTROL MODULE DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Possible Causes Source Perform Test
B1317 Battery Voltage High
  • Generator
4X4 Control Module Go to Pinpoint Test B  under PINPOINT TESTS .
B1318 Battery Voltage Low
  • Blown fuse (B+)
  • Intermittent open on power circuit
  • 4X4 control module connector
4X4 Control Module CHECK smart junction box (SJB) fuses 11 (10A) and 35 (10A). If fuses are OK, go to Pinpoint Test B  under PINPOINT TESTS .
P1635 Tire/Axle Out of Acceptable Range
  • Incorrect size tire installed on vehicle
  • Wheel speed sensor failure
  • Flat or under-inflated tire
4X4 Control Module Go to Pinpoint Test G  under PINPOINT TESTS .
P1824 4-Wheel Drive Clutch Relay Circuit Failure
  • Short to ground on active torque control coupling (ATCC) solenoid (part of rear axle) high circuit
  • 4X4 control module failure
4X4 Control Module CHECK SJB fuse 11 (10A). If the fuse is OK, go to Pinpoint Test E  under PINPOINT TESTS .
P1825 4-Wheel Drive Clutch Relay Open Circuit
  • 4X4 control module harness connector
  • Open in ATCC solenoid (part of rear axle) low circuit
  • Open in ATCC solenoid high circuit
  • Short to ground on ATCC solenoid low circuit
  • Short to ground on ATCC solenoid high circuit
  • Open coil inside ATCC solenoid
  • Short to voltage in ATCC solenoid low circuit
  • 4X4 control module failure
4X4 Control Module CHECK SJB fuses 11 (10A) and 35 (10A). If the fuses are OK, go to Pinpoint Test E  under PINPOINT TESTS .
U0100 Lost Communication with ECM/PCM
  • Controller area network (CAN) bus fault
  • No data received by 4X4 control module from PCM
4X4 Control Module Go to Pinpoint Test D  under PINPOINT TESTS .
U0121 Lost Communication with Anti-lock Brake System (ABS) Control Module
  • CAN bus fault
  • No data received by 4X4 control module from ABS control module
4X4 Control Module Go to Pinpoint Test D  under PINPOINT TESTS .
U0415 Invalid Data Received From Anti-lock Brake System (ABS) Control Module
  • Invalid data received from ABS module
  • Data out of range
4X4 Control Module Go to Pinpoint Test C  under PINPOINT TESTS .