Selector Lever Knob: Installation

All vehicles 

1. Route the TC switch electrical connector harness through the selector lever and install the shift knob and 2 new screws. Loosely install both screws before tightening.
   • Tighten to 2 N.m (18 lb-in).
Fig 1: Routing TC Switch Electrical Connector Harness Through Selector Lever
Courtesy of FORD MOTOR CO.
NOTE: Be sure that the selector lever knob bezel is correctly installed on the selector lever knob.
2. Install new selector lever knob trim covers.
Fig 2: Identifying Selector Lever Knob Trim Covers
Courtesy of FORD MOTOR CO.

EDGE only 

3. Route the TC switch electrical connector wires behind the selector lever bezel light bulb wires.
   1. TC switch electrical connector wires
   2. Selector lever light bulb wires
Fig 3: Identifying Selector Lever Light Bulb Wires
Courtesy of FORD MOTOR CO.

All vehicles 

NOTE: Center console side trim cover removed for clarity.
4. Connect the TC switch electrical connector.
Fig 4: Locating Transmission Control (TC) Switch Electrical Connector
Courtesy of FORD MOTOR CO.
5. Install the center console trim cover.
Fig 5: Identifying Center Console Trim Cover
Courtesy of FORD MOTOR CO.

MKX only 

6. Install the selector lever trim ring.
Fig 6: Locating Selector Lever Trim Ring
Courtesy of FORD MOTOR CO.