Selector Lever Bezel: Installation

Expedition 

1. Connect the electrical harness onto the bezel.
   Fig 1: Locating Electrical Harness From Bezel

   Courtesy of FORD MOTOR CO.

   All vehicles 

2. Align the brake shift interlock override tab into its guide.
   Fig 2: Aligning Brake Shift Interlock Override Tab Into Guide

   Courtesy of FORD MOTOR CO.
3. Install the selector lever bezel onto the selector lever housing.
   Fig 3: Locating Selector Lever Bezel Tabs

   Courtesy of FORD MOTOR CO.
4. Connect the Tow/Haul switch electrical connector and install the selector lever knob.
   Fig 4: Locating Tow/Haul Switch Electrical Connector

   Courtesy of FORD MOTOR CO.
5. Install a new LH selector lever knob screw.
   • Tighten to 2 Nm (18 lb-in).
     Fig 5: Locating LH Selector Lever Knob Screw

     Courtesy of FORD MOTOR CO.
6. Install a new RH selector lever knob screw.
   • Tighten to 2 Nm (18 lb-in).
     Fig 6: Locating Discard RH Selector Lever Knob Screw

     Courtesy of FORD MOTOR CO.
NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
Fig 7: Installing LH Selector Lever Knob Cover
Courtesy of FORD MOTOR CO.
7. Install a new LH selector lever knob cover.
NOTE: Wood-trimmed vehicles have a rubber damper not found on other trim levels.
Fig 8: Installing RH Selector Lever Knob Cover
Courtesy of FORD MOTOR CO.
8. Install a new RH selector lever knob cover.
9. Install the console upper trim and the screw.
   Fig 9: Locating Console Upper Trim And Screw

   Courtesy of FORD MOTOR CO.
10. Install the PRNDL trim, console tray and cup holder insert.
    Fig 10: Identifying PRNDL Trim, Console Tray And Cup Holder Insert

    Courtesy of FORD MOTOR CO.

    Funkmaster Flex vehicles 

11. Using alcohol, remove the double-sided adhesive tape from the serial numbered name plate and floor console finish panel surfaces.
12. Use a suitable double-sided adhesive tape and apply 6 new tape strips to the bottom of the serial numbered name plate, as indicated.
13. Position the serial numbered name plate onto the floor console finish panel and apply downward pressure, to securely fasten the name plate to the floor console finish panel.
    Fig 11: Identifying Serial Numbered Name Plate Position

    Courtesy of FORD MOTOR CO.
14. Verify brake shift interlock function.