Programming the Perimeter Lighting Feature Using the Door Lock Control Switch
NOTE:
The following steps must be carried out within 30 seconds or the procedure needs to be repeated. If the procedure needs to be repeated, wait 30 seconds between programming sessions.
- Turn the ignition switch from the OFF to the ON position.
- Press the unlock button on the door lock control switch 3 times.
- Turn the ignition switch from the ON to the OFF position.
- Press the unlock button on the door lock control switch 3 times.
- Turn the ignition switch to the ON position. The horn chirps once to indicate that programming mode is entered.
- Within 30 seconds of entering the programming mode, press the unlock button on the door lock control switch twice to enable/disable the perimeter lighting feature. The horn chirps once if the perimeter lighting is disabled or a chirp followed by a honk if the perimeter lighting is enabled.
- Programming ends when the ignition switch state changes or times out after 2 minutes.
NOTE:
The unlock button must be pressed twice within 5 seconds.