Removal and Installation
- Disconnect the ignition coil-on-plug electrical connector.
- Remove the bolt and the ignition coil-on-plug.
- Remove the ignition coil-on-plug, using a twisting motion while pulling up on the ignition coil-on-plug.
- To install, tighten to 6 Nm (53 lb-in).
- To install, reverse the removal procedure.
- Apply a light coat of dielectric compound to the inside of the ignition coil boots.
NOTE:
Verify that the ignition coil-on-plug spring is correctly located inside the ignition coil-on-plug boot and that there is no damage to the tip of the boot.