Parking Aid Module (PAM)
PARKING AID MODULE (PAM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B1B44:01 | Right Rear Outer Sensor: General Electrical Failure | Go To PINPOINT TEST B . |
| B1B44:96 | Right Rear Outer Sensor: Component Internal Failure | Go To PINPOINT TEST B . |
| B1B46:01 | Right Rear Inner Sensor: General Electrical Failure | Go To PINPOINT TEST B . |
| B1B46:96 | Right Rear Inner Sensor: Component Internal Failure | Go To PINPOINT TEST B . |
| B1B48:01 | Left Rear Outer Sensor: General Electrical Failure | Go To PINPOINT TEST B . |
| B1B48:96 | Left Rear Outer Sensor: Component Internal Failure | Go To PINPOINT TEST B . |
| B1B50:01 | Left Rear Inner Sensor: General Electrical Failure | Go To PINPOINT TEST B . |
| B1B50:96 | Left Rear Inner Sensor: Component Internal Failure | Go To PINPOINT TEST B . |
| B1B52:12 | Rear Sounder-Park Aid: Circuit Short to Battery | CLEAR the DTCs. REPEAT the self-test. If DTC B1B52:12 is recorded again, INSTALL a new Parking Aid Module (PAM). REFER to PARKING AID MODULE (PAM) . REPEAT the self-test. |
| B1B52:14 | Rear Sounder-Park Aid: Circuit Short to Ground or Open | CLEAR the DTCs. REPEAT the self-test. If DTC B1B52:14 is recorded again, INSTALL a new PAM . REFER to PARKING AID MODULE (PAM) . REPEAT the self-test. |
| U0140:87 | Lost Communication With Body Control Module: Missing Message | Go To PINPOINT TEST F . |
| U0155:87 | Lost Communication With Instrument Panel Cluster (IPC ) Control Module: Missing Message | Go To PINPOINT TEST F . |
| U3000:41 | Control Module: General Check Sum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U3000:46 is recorded again. INSTALL a new PAM . REFER to PARKING AID MODULE (PAM) . CLEAR all DTCs. REPEAT the self-test. |
| U3000:46 | Control Module: Calibration/Parameter Memory Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U3000:46 is recorded again, INSTALL a new PAM . REFER to PARKING AID MODULE (PAM) . REPEAT the self-test. |
| U3000:54 | Control Module: Missing Calibration | The PAM needs to be configured. CARRY OUT Programmable Module Installation (PMI) for the PAM . REFER to MODULE CONFIGURATION . CLEAR all DTCs. REPEAT the self-test. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | Go To PINPOINT TEST C . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | Go To PINPOINT TEST D . |