Selector Lever Knob: Installation

Vehicles with a TCS 

1. Route the TCS  wiring harness through the selector lever bezel and connect the TCS  electrical connector.
   Fig 1: Locating TCS Electrical Connector

   Courtesy of FORD MOTOR CO.
NOTE: Selector lever removed for clarity.
2. Position the selector lever bezel in place.
   • Be sure the 4 tabs are locked in place.
     Fig 2: Locating Selector Lever Bezel Tabs Position

     Courtesy of FORD MOTOR CO.

   All vehicles 

3. Position the selector lever knob and knob bezel in place and install the screws.
   Fig 3: Locating Screws From Selector Lever Knob

   Courtesy of FORD MOTOR CO.
4. Slide the lower selector lever knob bezel up and snap it into place.
   Fig 4: Sliding Lower Selector Lever Knob Bezel Up

   Courtesy of FORD MOTOR CO.

   Vehicles with a TCS 

5. Install the upper console panel.
   Fig 5: Locating Floor Console Finish Panel

   Courtesy of FORD MOTOR CO.
6. Install the selector lever bezel trim ring.
   Fig 6: Locating Selector Lever Trim Ring

   Courtesy of FORD MOTOR CO.