Transaxle Drive Cycle Test: Notes

NOTE: Always drive the vehicle in a safe manner according to driving conditions and obey all traffic laws.

NOTE: The Transaxle Drive Cycle Test must be followed exactly. Transaxle failure must occur 4 times consecutively for shift error DTC to be set, and 5 times consecutively for continuous Torque Converter Clutch (TCC) code to set.

NOTE: When carrying out the Transaxle Drive Cycle Test, refer to the Solenoid Application Chart for correct solenoid operation.

After carrying out the Self Test, use the Transaxle Drive Cycle Test for checking continuous codes.

Record and then erase Self Test DTCs.
Warm engine to normal operating temperature.
Make sure transmission fluid level is correct.
With transaxle in Overdrive (O/D) position, moderately accelerate from stop to 80 km/h (50 mph). This allows the transaxle to shift into 4th gear. Hold speed and throttle open steady for a minimum of 15 seconds.

NOTE: Pressure Control Solenoid A (PCA), Electronic Pressure Control (EPC) and Variable Force Solenoid (VFS) all refer to the solenoids. PCA is preferred for this transmission because the scan tool displays PCA.

With transaxle in 4th gear and maintaining steady speed and throttle opening, lightly apply and release brake to operate stop lamps. Then hold speed and throttle steady for a minimum of 5 seconds.
Brake to a stop and remain stopped for a minimum of 20 seconds.
Repeat Steps 4 through 6 at least 5 times.
Carry out Self Test and record continuous DTCs.