LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2009 >> Focus S, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Disassembly And Assembly Of Subassemblies >> Main Control Valve Body >> Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Main Control Valve Body: Assembly

    NOTE: The top side of the separator plate has a bonded gasket.
    NOTE: The separator gasket goes on the bottom side.
    NOTE: Inspect the main control valve body.
  1. Install new control valve body plate assembly and separator gaskets.
    2. Fig 1: Locating Control Valve Body Plate
    GF0039892Courtesy of FORD MOTOR CO.
    NOTE: Do not fully tighten the bolts at this stage.
  2. Assemble the main control valve body and loosely install the bolts.
    3. Fig 2: Locating Main Control Valve Body Bolts
    GF0039891Courtesy of FORD MOTOR CO.
  3. Install the seals.
    4. Fig 3: Locating Seals
    GF0039890Courtesy of FORD MOTOR CO.
  4. Install a new solenoid body gasket.
    5. Fig 4: Locating Solenoid Body Gasket
    GF0039889Courtesy of FORD MOTOR CO.
  5. Install the solenoid body and loosely install the bolts.
    6. Fig 5: Locating Solenoid Body Bolts
    GF0039893Courtesy of FORD MOTOR CO.
  6. Tighten the solenoid body bolts in the sequence shown in illustration.
    • Tighten to 9 Nm (80 lb-in).
    7. Fig 6: Identifying Tightening Sequence For Solenoid Body Bolts
    GF0039894Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals