LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2009 >> Fusion S, Automatic >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission External Controls >> General Procedures >> Selector Lever Cable Adjustment
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Selector Lever Cable Adjustment

6-speed transaxle 

  1. Vehicles equipped with a 3.5L engine, remove the Air Cleaner (ACL) assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.5L article.
  2. Disconnect the selector lever cable end from the manual control lever.
  3. Fig 1: Locating Selector Lever Cable End
    GF0028947Courtesy of FORD MOTOR CO.
  4. Place the manual control lever in DRIVE.
    1. Place the manual control lever in PARK.
    2. Move the manual control lever counterclockwise 3 detents to the DRIVE position.
  5. Fig 2: Moving Manual Control Lever Counterclockwise
    GF0029882Courtesy of FORD MOTOR CO.

    FNR5 transaxle 

  6. Disconnect the selector lever cable end from the manual control lever.
  7. Fig 3: Locating Selector Lever Cable End
    GF0029820Courtesy of FORD MOTOR CO.
    NOTE: Transaxle removed from vehicle for clarity.
  8. Place the manual control lever in NEUTRAL.
    1. Place the manual control lever in PARK.
    2. Move the manual control lever clockwise 3 detents to the DRIVE position.
  9. Fig 4: Moving Manual Control Lever Clockwise
    GF0029883Courtesy of FORD MOTOR CO.

    All vehicles 

  10. Place the selector lever in DRIVE.
  11. Fig 5: Locating Gear Selector Lever
    GF0029884Courtesy of FORD MOTOR CO.
  12. Unlock the adjuster by sliding the locking tab over.
  13. Fig 6: Sliding Locking Tab Over
    GF0029885Courtesy of FORD MOTOR CO.
  14. Slide the selector lever cable end forward or backward to align it with the manual control lever.
  15. Fig 7: Sliding Cable End
    GF0029886Courtesy of FORD MOTOR CO.
    NOTE: FNR5 selector lever cable end shown, 6-speed transaxle similar.
  16. With the adjuster locking tab released, connect the selector lever cable end to the manual control lever.
  17. Fig 8: Locating FNR5 Selector Lever Cable
    GF0029887Courtesy of FORD MOTOR CO.
    NOTE: FNR5 selector lever cable end shown, 6-speed transaxle similar.
  18. Slide the release tab back to lock the adjuster.
  19. Fig 9: Releasing Tab Back To Lock Adjuster
    GF0029888Courtesy of FORD MOTOR CO.
  20. For vehicles equipped with a 3.5L engine, install the ACL assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING - 3.5L article.
  21. Verify that the vehicle starts in PARK and NEUTRAL only and that the reverse lamps illuminate in REVERSE.