Component testing procedure
WARNING: This page is about a different car, the 2009 Ford Mustang. However, it is still accessible from the selected car via links, so may be relevant.
COMPONENT TESTING PROCEDURE
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Turn signal | 6 and 10 | Left turn | Closed circuit |
| 7 and 10 | Right turn | Closed circuit | |
| Flash-to-pass | 8 and 10 | Pull and hold lever stalk toward steering wheel | Open circuit |
| 9 and 10 | Closed circuit | ||
| High beam/Low beam | 8 and 10 | Lever stalk in detent toward steering wheel | Closed circuit |