Selector Lever Knob: Installation

Vehicles equipped with a TC switch 

1. Route the TC switch wiring harness through the selector lever bezel and connect the TC switch electrical connector.
Fig 1: Identifying Connector
Courtesy of FORD MOTOR CO.
NOTE: Selector lever removed for clarity.
2. Position the selector lever bezel in place.
   • Be sure the 4 tabs are locked in place.
Fig 2: Identifying Tabs
Courtesy of FORD MOTOR CO.

All vehicles 

3. Position the selector lever knob and knob bezel in place and install the screws.
Fig 3: Identifying Screws
Courtesy of FORD MOTOR CO.
4. Slide the lower selector lever knob bezel up and snap it into place.
Fig 4: Sliding Lower Selector Lever Knob Bezel Up
Courtesy of FORD MOTOR CO.

Vehicles equipped with a TC switch 

5. Install the upper console panel.
Fig 5: Identifying Upper Console Panel
Courtesy of FORD MOTOR CO.
6. Install the selector lever bezel trim ring.
Fig 6: Identifying Selector Lever Bezel Trim Ring
Courtesy of FORD MOTOR CO.