Removal and Installation
NOTE:
Electronic modules are sensitive to electrical charges. The Anti-lock Brake System (ABS) module can be damaged if exposed to these charges.
NOTE:
Do not allow any brake fluid or foreign material to enter the mating side of the Anti-lock Brake System (ABS) module or damage to the solenoids can occur.
- Remove the Hydraulic Control Unit (HCU). For additional information, refer to HYDRAULIC CONTROL UNIT (HCU) .
- Remove the 4 ABS module screws and the ABS module.
- To install, tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
- Carry out the IVD Initialization sequence. Follow the scan tool directions.
NOTE:
Visually inspect the ABS module terminals for damage before installation.