LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2010 >> Flex SE >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Charging System & Fuel Control System >> Removal And Installation >> Fuel Pump Control Module >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

  1. Remove the RH C-pillar trim panel. For additional information, Refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Disconnect the Fuel Pump (FP) module electrical connector.
  3. NOTE: Do not overtighten the fasteners or damage to the module will occur.

    Remove the 2 FP  control module nuts.

    • To install, tighten to 5 Nm (44 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals