LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2010 >> Flex SE >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Electronic Engine Controls >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

  1. Install the PCM and the 2 nuts.
    • Tighten to 8 Nm (71 lb-in).
  2. Connect the 3 PCM electrical connectors.
  3. Install the cowl panel grille. For additional information, Refer to FRONT END BODY PANELS .
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, Refer to MODULE CONFIGURATION .
  5. Reprogram the Passive Anti-Theft System (PATS). Carry out the Parameter Reset procedure. For additional information, Refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
  6. Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.
scientia non olet · About LEMON Manuals