Torca® Clamp

Remove the nut from the Torca® clamp.
Grind the spot weld and the tac weld from the Torca® clamp and remove the clamp.
Clean the uneven surface area and position the new Torca® clamp.

Fig 1: Identifying Torca® Clamp And Uneven Surface Area
Courtesy of FORD MOTOR CO.

NOTE: Make sure the clamp position is no more than 27.5 mm (1.08 in) or less than 25.5 mm (1 in) from the inlet of the resonator pipe.

Fig 2: Identifying Clamp Position

Courtesy of FORD MOTOR CO.

Make sure the back of the slot is covered by the clamp and the button is fully seated inside the notch.

NOTE: Do not tighten the clamp until the exhaust system has been aligned.