LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Edge Limited, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Anti-Theft - Passive Anti-Theft System (Pats) >> General Procedures >> Key Programming - Program a Key Using Two Programmed Keys >> With Intelligent Access (IA)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With Intelligent Access (IA)

NOTE: This procedure works only if 2 or more programmed keys are available. If 2 programmed keys are not available, refer to KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
NOTE: This procedure works only if the customer spare key programming is enabled. If customer spare key programming is disabled, refer to Key Programming - Enable/Disable Spare Key Programming  or KEY PROGRAMMING USING DIAGNOSTIC EQUIPMENT .
  1. The ignition must be off to begin this procedure.
    NOTE: Carry out steps 1-7 within 30 seconds to successfully enter programming mode.
  2. Place two programmed Intelligent Access (IA) keys inside the passenger compartment.
  3. Insert an unprogrammed IA  key in the backup transceiver slot in the center console.
  4. Press the driver or passenger door lock control switch to the unlock position 3 times.
  5. Press and release the brake pedal once.
  6. Press the driver or passenger door lock control switch to the lock position 3 times.
  7. Press and release the brake pedal once.
    NOTE: After this step is followed, the indicator on the start/stop switch begins to flash rapidly, indicating that programming mode has been entered.
  8. Press the start/stop switch to program the new key. A message displays on the message center indicating the new IA  key has been programmed.
  9. Exiting the programming mode is accomplished if one of the following occurs:
    • The driver or passenger door lock control switch is pressed
    • 1 minute has passed since entering programming mode or since the IA  key was programmed
    • Brake pedal is pressed
    • The ignition transitions from OFF to any other state
    • The maximum number of keys are programmed
  10. Verify the operation of the new key by pressing the lock and unlock buttons on the IA  key, then place the new key inside the passenger compartment and start the engine with the new key. Make sure the original keys are outside of the vehicle when verifying the new key operation.
  11. If it is desired to program an additional key (only up to 4 keys total can be programmed), repeat Steps  1 -  8 for the additional key that needs to be programmed.
scientia non olet · About LEMON Manuals