Removal and Installation

RH side 

NOTE: The upper intake manifold must be removed to access the RH ignition coil-on-plugs.
1. Remove the upper intake manifold. For additional information, refer to ENGINE - 3.5L or ENGINE - 3.7L

   Both sides 

2. Disconnect the 6 ignition coil-on-plug electrical connectors.
NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
3. Remove the 6 bolts and the 6 ignition coil-on-plugs.
   • To install, tighten to 7 Nm (62 lb-in).
4. Inspect the coil seals for rips, nicks or tears. Remove and discard any damaged coil seals.
   • To install, slide the new coil seal onto the coil until it is fully seated at the top of the coil.
     Fig 1: Locating Damaged Coil Seals

     Courtesy of FORD MOTOR CO.
5. To install, reverse the removal procedure.
   • Apply a small amount of dielectric grease to the inside of the ignition coil-on-plug boots before attaching to the spark plugs.