LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Edge SE, FWD >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> General Procedures >> Torca® Clamp
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Torca® Clamp

  1. Remove the nut from the Torca® clamp.
  2. Grind the spot weld from the Torca® clamp and remove the clamp.
  3. Clean the Torca® clamp surface area on the muffler and tailpipe assembly and then position a new Torca® clamp.
    4. NOTE: Make sure the clamp position is no more than 10 mm (0.393 in) to 13 mm (0.511 in) from the inlet of the muffler and tailpipe assembly.
    Fig 1: Identifying Distance Between Clamp And Inlet Of Muffler And Tailpipe Assembly
    G07402266Courtesy of FORD MOTOR CO.
  4. Make sure the button is fully seated inside the notch.
    5. NOTE: Do not tighten the clamp until the exhaust system has been aligned.
  5. Tighten the Torca® clamp.
    • Tighten to 47 Nm (35 lb-ft).
scientia non olet · About LEMON Manuals