Front Controls Interface Module (FCIM)
FRONT CONTROLS INTERFACE MODULE (FCIM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| U0140:00 | Lost Communication With Body Control Module (GEM ): No Sub Type Information | Go to PINPOINT TEST AA . |
| U0184:00 | Lost Communication With Radio (ACM ): No Sub Type Information | Go to PINPOINT TEST AS . |
| U2013:63 | Switch Pack: Circuit / Component Protection Time-Out | Go to PINPOINT TEST R . |
| U2014:41 | Control Module Hardware: General Checksum Failure | CLEAR the DTCs. REPEAT the self-test. If DTC U2014:41 is retrieved again, INSTALL a new Front Controls Interface Module (FCIM). Refer to FRONT CONTROLS INTERFACE MODULE (FCIM) in this service information. TEST the system for normal operation. |
| U201A:51 | Control Module Main Calibration Data: Not Programmed | CLEAR the DTCs. REPEAT the self-test. If DTC U201A:51 is retrieved again, INSTALL a new FCIM . Refer to FRONT CONTROLS INTERFACE MODULE (FCIM) in this service information. TEST the system for normal operation. |
| U3003:16 | Battery Voltage: Circuit Voltage Below Threshold | Go to PINPOINT TEST AD . |
| U3003:17 | Battery Voltage: Circuit Voltage Above Threshold | Go to PINPOINT TEST AN . |