Power Trunk / Liftgate Control Module: Service and Repair

Liftgate/Trunk Module (LTM)

Removal and Installation









1. Remove the rear quarter trim panel. For additional information, refer to Interior Trim and Ornamentation Quarter Trim Panel.

2. Remove the Liftgate/Trunk Module (LTM).

1. Disconnect the electrical connectors.

2. Remove the bolt.
- To install, tighten to 9 Nm (80 lb-in).





3. To install, reverse the removal procedure.
- Initialize the power liftgate. For additional information, refer to Power Liftgate Initialization Procedures.