LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Explorer Base, FWD, 6F55 >> Repair and Diagnosis >> Engine Mechanical >> Exhaust System >> General Procedures >> Torca Clamp >> General Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

General Procedure

  1. Remove the nut from the Torca® clamp.
  2. Grind the spot weld from the Torca® clamp and remove the clamp.
  3. Clean the Torca® clamp surface area on the muffler and tailpipe assembly and then position a new Torca® clamp.
    4. NOTE: Make sure the clamp position is no more than 10 mm (0.393 in) to 13 mm (0.511 in) from the inlet of the muffler and tailpipe assembly.
  4. Make sure the button is fully seated inside the notch.
    5. NOTE: Do not tighten the Torca® clamp until the exhaust system has been aligned.
  5. Tighten the Torca® clamp retainer.

    Tighten to 55 Nm (41 lb-ft).

scientia non olet · About LEMON Manuals