LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Fiesta S, Standard >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Electronic Engine Controls >> Removal And Installation >> Powertrain Control Module (PCM) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Powertrain Control Module (PCM): Installation

    NOTE: The PCM and PCM cover can be easily damaged by excessive fastener torque. Do not exceed 6 Nm.
  1. Position the PCM and install the bolt.
    • Tighten to 6 Nm (53 lb-in).
  2. Connect the 3 PCM electrical connectors.
    3. NOTE: The PCM and PCM cover can be easily damaged by excessive fastener torque. Do not exceed 6 Nm.
  3. Position the PCM cover and install the bolt.
    • Tighten to 6 Nm (53 lb-in).
  4. Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation (PMI) procedure. For additional information, refer to MODULE CONFIGURATION .
  5. Reprogram the PATS  . Carry out the Parameter Reset procedure. For additional information, refer to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
scientia non olet · About LEMON Manuals