Normal Operation

When the ignition is turned ON a relay inside the power steering control module (PSCM) is energized, which sends power to other portions of the module. The PSCM monitors this relay output and will set a DTC if output is not detected.

NOTE: If a damaged bellows boot(s) was discovered during Inspection and Verification and this pinpoint test DOES NOT lead to the installation of a new EPAS gear or bellows boot(s), then go to PINPOINT TEST K to address the damaged boot(s) before returning the vehicle to the customer.

D1: CHECK FOR RETURNING DTCS

Clear the PSCM DTCs.

Cycle the ignition to OFF and then back to RUN.

Press Read Vehicle Information button to retrieve DTC s from the vehicle.

NOTE: DTCs may be displayed from previous diagnostic actions.

Is DTC U3000:72 present?

Yes	No
Install a new EPAS gear. REFER to POWER STEERING SYSTEM .	The condition to set the DTC is not present at this time. In cold climates or climates where frost is possible, the relay contacts could develop a layer of frost which may prevent a clean connection between the relay contacts. It may be necessary to allow the vehicle to remain outside overnight in a cold climate to duplicate the DTC trigger conditions. If the DTC was set during cold or frosty conditions, attempt to recreate the fault by allowing the vehicle to remain overnight in a cold or frosty environment. If the DTC was not set during cold or frosty conditions, RETURN the vehicle to the customer.

Yes

Install a new EPAS gear.
REFER to POWER STEERING SYSTEM .

The condition to set the DTC is not present at this time.
In cold climates or climates where frost is possible, the relay contacts could develop a layer of frost which may prevent a clean connection between the relay contacts. It may be necessary to allow the vehicle to remain outside overnight in a cold climate to duplicate the DTC trigger conditions.
If the DTC was set during cold or frosty conditions, attempt to recreate the fault by allowing the vehicle to remain overnight in a cold or frosty environment.
If the DTC was not set during cold or frosty conditions, RETURN the vehicle to the customer.

D2: ATTEMPT TO RECREATE THE FAULT CONDITIONS

Park the vehicle in a cold or frosty environment and allow it to remain there overnight.

NOTE: Do not allow the vehicle to warm up before carrying out the PSCM self-test.

Ignition ON, engine OFF.

Press Read Vehicle Information button to retrieve DTC s from the vehicle.

NOTE: DTCs may be displayed from previous diagnostic actions.

Is DTC U3000:72 present?

Yes	No
INSTALL a new EPAS gear. REFER to POWER STEERING SYSTEM .	The condition to set the DTC is not present at this time. RETURN the vehicle to the customer.