ABS Module Calibration

The ABS module must be configured before it is calibrated. The ABS module must be calibrated if any one of the following components are installed new:

• ABS module
• HCU 
• RCM 

Calibration is required for the ABS module to learn the "at rest" or "zero position" of the stability control components. If a DTC is set for any stability control component, the DTC must be repaired before carrying out the calibration procedure. The sliding-car icon flashes after clearing any stability control DTCs, indicating that the system is not calibrated.

If a DTC is retrieved after calibration, refer to the ABS MODULE DTC CHART  in this information.

To calibrate the ABS module, carry out the IVD Initialization sequence. Follow the instructions provided by the scan tool.