LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2011 >> Focus SES, Standard >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Diagnosis And Testing >> Generator >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis And Testing: Generator: Installation

  1. If removed, install the generator upper air duct and the bolt.
    • Tighten to 12 Nm (106 lb-in).
  2. Install the generator and generator bolt. Hand-tighten the bolt. Do not torque the bolt at this time.
  3. Install the 2 generator studs.
    • Tighten to 24 Nm (18 lb-ft).
  4. Install the 2 generator nuts.
    • Tighten to 47 Nm (35 lb-ft).
  5. Tighten the generator bolt.
    • Tighten to 47 Nm (35 lb-ft).
  6. Position the generator B+ terminal on the generator and install the nut.
    • Tighten the nut to 17 Nm (150 lb-in) and position the protective cover on the nut.
  7. Install the lower generator air duct.
  8. Rotate the FEAD belt tensioner clockwise and install the FEAD belt.
  9. Position the accessory drive splash shield and install the 2 screws.
    • Tighten the screws to 5 Nm (44 lb-in).
  10. Install the center support bracket and the 3 bolts.
    • Tighten the bolts to 30 Nm (22 lb-ft).
  11. Install the RH halfshaft. For additional information, refer to FRONT DRIVE HALFSHAFTS article.
  12. Connect the generator electrical connector.
  13. Connect the battery. For additional information, refer to BATTERY, BATTERY MOUNTING & BATTERY CABLES article.
scientia non olet · About LEMON Manuals