Body Control Module B (BCM-B)
BODY CONTROL MODULE B (BCM-B) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Action |
|---|---|---|
| B109F:08 | Intrusion Sensor Module: Bus Signal/Message Failures | GO to PINPOINT TEST E . |
| B109F:49 | Intrusion Sensor Module: Internal Electronic Failure | INSTALL a new intrusion and inclination sensor. REFER to INTRUSION AND INCLINATION SENSOR in this service information. TEST the system for normal operation. |
| B109F:55 | Intrusion Sensor Module: Not Configured | REFER to MODULE COMMUNICATIONS NETWORK - MODULE CONFIGURATION article. |
| B109F:97 | Intrusion Sensor Module: Component Or System Operation Obstructed Or Blocked |
NOTE:
The Body Control Module B (BCM-B) DTC B109F: 97 is a continuous memory and on-demand DTC that sets when there are 3 successive failures of the intrusion and inclination sensor module to arm and there is no indication of a module fault and the communication link between the module and the BCM-B
appears to have sufficient integrity. CHECK for any blockages/restrictions near the intrusion and inclination sensor that may hinder/affect the operation of the sensor. |
| All other DTCs | - | REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULE article. |