Programming the Auto-Unlock Feature Using the Instrument Cluster Message Center
NOTE:
The auto-unlock feature can be activated or deactivated independently of the autolock feature.
NOTE:
The auto-unlock feature of the SJB can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to
MODULE CONFIGURATION SYSTEM
Article.
- Switch the ignition from the OFF to the RUN mode.
- Press the SETUP button on the message center switch until AUTOUNLOCK < ON > OFF is displayed.
- Press the RESET button to select ON or OFF. If auto-unlock is enabled, the message center will have brackets around the < ON > display. If auto-unlock is disabled, the message center will have brackets around the < OFF > display.