Programming the Auto-Unlock Feature Using the Keyless Entry Keypad
NOTE:
The auto-unlock feature can be activated or deactivated independently of the autolock feature.
NOTE:
The auto-unlock feature of the SJB can also be configured ON or OFF with the scan tool. For additional information on module configuration, refer to
MODULE CONFIGURATION SYSTEM
Article.
- Switch the ignition to the OFF mode and close all vehicle doors.
- Enter the factory set 5-digit keyless entry keypad code.
- Touch and hold the 3/4 button on the keypad. While holding the 3/4 button, touch and release the 7/8 button. While still holding the 3/4 button, touch and release the 7/8 button a second time.
- Release the 3/4 button. The horn chirps once if auto-unlock is disabled or twice (one short chirp followed by a honk) if auto-unlock is enabled.