Electronic Engine Controls
WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.
The electronic engine controls consist of the:
- powertrain control module (PCM).
- cylinder head temperature (CHT) sensor.
- camshaft position (CMP) sensor.
- crankshaft position (CKP) sensor.
- mass air flow (MAF) sensor.
- heated oxygen sensor (HO2S).
- catalyst monitor sensor.
- variable camshaft timing (VCT) oil control solenoid.
- knock sensor (KS).
The PCM carries out the following functions:
- accepts input from various engine sensors to compute the fuel flow rate necessary to maintain a prescribed air/fuel ratio throughout the entire engine operational range.
- outputs a command to the fuel injectors to meter the appropriate quantity of fuel.
The CHT sensor:
- sends the PCM a signal indicating cylinder head temperature.
- resistance decreases as coolant temperature increases.
The CMP sensor:
- sends the PCM a signal indicating camshaft position used for fuel synchronization.
The CKP sensor:
- sends the PCM a signal indicating crankshaft position.
- is essential for calculating spark timing.
The MAF sensor:
- uses a hot wire sensing element to measure the amount of air entering the engine. Air passing over the hot wire causes it to cool.
The HO2S:
- creates a voltage signal dependent on exhaust oxygen content.
- provides feedback information to the PCM used to calculate fuel delivery.
The catalyst monitor sensor:
- monitors oxygen content after it flows through the catalytic converter.
- provides a voltage to the PCM used to calculate catalytic converter integrity.
The KS:
- is used to detect engine detonation.
- sends a voltage signal to the PCM.
- is able to provide a signal which retards the ignition timing, as necessary.
The variable camshaft timing (VCT) oil control solenoid:
- is an electrically controlled hydraulic valve that directs engine oil to the camshaft phase. Once the PCM transmits a signal, the solenoid moves a valve spool, directing oil into the camshaft phase cavity. This action changes valve timing by either inducing an advance or retard condition. The camshaft is, thereby repositioned in relation to crankshaft timing and allows for optimum engine performance and lower emissions.