Program a MyKey™: Notes
NOTE:
After a MyKey™ has been programmed, the remaining standard key(s) (the key[s] that is not programmed with the MyKey™ feature) is referred to as an "administrator key(s)" or "admin" key(s). There must always be at least one admin key. The Instrument Cluster (IC) does not allow the last admin key to be programmed into a MyKey™ restricted key. Both the admin key and the MyKey™ restricted key can be used to see how many MyKey™ and admin keys are programmed to the vehicle, and how many total miles have been driven with the MyKey™ feature active (using the message center). The MyKey™ is the one with the restricted status. The admin key does not have any restrictions.
NOTE:
The MyKey™ feature can be cleared within the same key cycle that it was programmed. Follow the Disable MyKey™ Restricted Features procedure
to clear the key of any restricted MyKey™ status. If the key has been cycled, an admin key is required to disable the MyKey™ programming.
NOTE:
The MyKey™ feature can only be configured or disabled with an admin key.
NOTE:
The MyKey™ feature allows you to program/configure a restricted driving mode on one (or more) standard key(s) supplied with the vehicle or any (Passive Anti-Theft System (PATS)) programmed spare key(s) to promote good driving habits. All but one of the keys that are programmed to the vehicle can be programmed to a MyKey™ restricted key status. The MyKey™ is a restricted key for consecutive key cycles until the MyKey™ feature is disabled. When the MyKey™ feature is programmed, several features are modified/or can be modified:
NOTE:
The standard restricted features below cannot be configured in any way.