LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Escape XLS, FWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Removal And Installation >> Generator - 2.5L >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Generator - 2.5L: Installation

  1. Install the 3 screws and the generator upper air duct.
    • To install, tighten to 4 Nm (35 lb-in).
  2. Working from the top of the vehicle, install the generator and the generator stud.
  3. Install the 2 generator stud nuts hand-tight.
  4. Install the generator B+ cable and install the generator B+ terminal nut.
    • To install, tighten to 17 Nm (150 lb-in).
  5. Connect the generator electrical connector.
  6. Position the generator B+ protective cover on the B+ terminal.
  7. Working from under the vehicle, install the lower generator bolt hand-tight.
  8. Tighten the 2 generator stud nuts.
    • To install, tighten to 47 Nm (35 lb-ft).
  9. Install the lower generator air duct.
  10. Tighten the generator bolt.
    • To install, tighten to 47 Nm (35 lb-ft).
  11. Rotate the FEAD belt tensioner clockwise and position the accessory drive belt onto the pulleys.
  12. Install the 5 bolts, 1 pushpin and the RH lower splash shield.
    • To install, tighten to 8 Nm (71 lb-in).
  13. Position the harness locator on the generator stud.
  14. Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
scientia non olet · About LEMON Manuals