Programming Memory Positions
NOTE:
Verify good battery condition before diagnosing the memory seat system. Poor battery condition may interfere with memory seat operation, even if vehicle starting is possible.
- Place the vehicle ignition to ON.
- To set memory position(s) move the memory driver seat, memory exterior mirrors (if equipped), memory adjustable pedals (if equipped) and memory tilt steering column (if equipped) to the preferred position using the appropriate switch(es).
- Press and hold a memory button (1 or 2) until a tone is heard (1.5 seconds). When the tone is heard, the memory programming is complete.
- Repeat the previous steps to program another memory position.
NOTE:
To program an Integrated Keyhead Transmitter (IKT) (remote entry transmitter), refer to Remote Keyless Entry Transmitter Programming and Remote Memory Activation in
HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS
.
NOTE:
Activation of the driver seat control switch, adjustable pedal control switch, exterior mirror control switch or power tilt steering column switch during memory programming will abort the operation.
NOTE:
If other tones or chimes are being produced, the memory save tone will not be heard because it is one of the lowest priorities.