LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Expedition 4WD >> Repair and Diagnosis >> Quick Lookups >> DTC Index >> Instrumentation, Message Center And Warning Chimes DTCS
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Instrumentation, Message Center And Warning Chimes DTCS

INSTRUMENT CLUSTER (IC) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
B1137 Data Not Programmed REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1138 Memory Full REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1139 Invalid Transmitter Identification Code REFER to HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS .
B1202 Fuel Sender Circuit Open GO to Pinpoint Test B .
B1204 Fuel Sender Circuit Short to Ground GO to Pinpoint Test B .
B1213 Anti-Theft Number of Programmed Keys is Below Minimum REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B1255 Air Temperature External Sensor Circuit Open GO to Pinpoint Test AI .
B1257 Air Temperature External Sensor Circuit Short to Ground GO to Pinpoint Test AI .
B1317 Battery Voltage High GO to Pinpoint Test AR .
B1318 Battery Voltage Low GO to Pinpoint Test AS .
B1342 ECU Is Faulted REPAIR all other DTCs first. REPEAT the self-test. CLEAR the DTC. If DTC B1342 is retrieved, INSTALL a new Instrument Cluster (IC). REFER to Instrument Cluster (IC) in this section. TEST the system for normal operation.
B1600 PATS Ignition Key Transponder Signal Is Not Received REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B1601 PATS Received Incorrect Key-Code From Ignition Key Transponder REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B1602 PATS Received Invalid Format Of Key-Code From Ignition Key Transponder REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B1681 PATS Transceiver Module Signal Is Not Received REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B1868 Lamp Air Bag Warning Indicator Circuit Failure REPEAT the self-test. CLEAR the DTC. If DTC B1868 is retrieved, INSTALL a new IC. REFER to Instrument Cluster (IC) in this section. TEST the system for normal operation.
B1915 Air Bag Driver Circuit Failure REPEAT the self-test. CLEAR the DTC. If DTC B1915 is retrieved, INSTALL a new IC. REFER to Instrument Cluster (IC) in this section. TEST the system for normal operation.
B2097 Compass Module Failure GO to Pinpoint Test AG .
B2103 Antenna Not Connected REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B2141 NVM Configuration Failure CARRY out a parameter reset. REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) . REPEAT the self-test. CLEAR the DTCs.
B2143 NVM Memory Failure REPEAT the self-test. CLEAR the DTC. If DTC B2143 is retrieved, INSTALL a new IC. REFER to Instrument Cluster (IC) in this section. TEST the system for normal operation.
B2431 Transponder Programming Failed REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
B2477 Module Configuration Failure CARRY OUT the Programmable Module Installation (PMI) procedure. REFER to MODULE CONFIGURATION . REPEAT the self-test. CLEAR the DTCs.
B2627 Fuel Sender Circuit Open #2 DISREGARD the DTC. Not applicable to this vehicle. If these codes are present, the IC is mis-configured.
B2628 Fuel Sender Circuit Short to Ground #2 DISREGARD the DTC. Not applicable to this vehicle. If these codes are present, the IC is mis-configured.
B2879 Fuel Tank Jet Pump Fault DISREGARD the DTC. Not applicable to this vehicle. If these codes are present, the IC is mis-configured.
C1945 Park Switch Indicates Park with Vehicle Moving GO to Pinpoint Test U .
C2784 RAM Checksum Failure REPEAT the self-test. CLEAR the DTC. If DTC C2784 is retrieved, INSTALL a new IC. REFER to Instrument Cluster (IC) in this section. TEST the system for normal operation.
U0037 Vehicle Communication Bus B GO to Pinpoint Test AY .
U0100 Lost Communication With ECM/PCM GO to Pinpoint Test AT .
U0101 Lost Communication With TCM GO to Pinpoint Test AU .
U0102 Lost Communication With Transfer Case Control Module (4X4 CM) GO to Pinpoint Test AV .
U0121 Lost Communication With ABS Control Module GO to Pinpoint Test AW .
U0122 Lost Communication With Vehicle Dynamics Control Module GO to Pinpoint Test AX .
U0140 Lost Communication With Body Control Module (GEM) GO to Pinpoint Test AY .
U0151 Lost Communication With Restraints Control Module (RCM) GO to Pinpoint Test AZ .
U0159 Lost Communication With Parking Assist Control Module (PAM) GO to Pinpoint Test BA .
U0164 Lost Communication With HVAC Control Module (EATC) GO to Pinpoint Test BB .
U0208 Lost Communication With Seat Control Module (DSM) GO to Pinpoint Test BC .
U0230 Lost Communication With Rear Gate Module (LTM) GO to Pinpoint Test BD .
U0242 Lost Communication With Headlamp Control Module (HCM-2) DISREGARD the DTC. Not applicable to this vehicle. If these codes are present, the IC is mis-configured.
U0244 Lost Communication With Running Board Control Module (PRB) GO to Pinpoint Test BE .
U2013 Compass Module is Not Responding GO to Pinpoint Test AG .
U2023 Fault Received From External Node DTC U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs.
U2050 No Application Present CARRY OUT the IC PMI. REFER to MODULE CONFIGURATION . If the DTC reappears, INSTALL a new IC. REFER to Instrument Cluster (IC) in this section. TEST the system for normal operation.
U2051 One or More Calibration Files Missing/Corrupt CARRY OUT the IC PMI. REFER to MODULE CONFIGURATION . If the DTC reappears, INSTALL a new IC. REFER to Instrument Cluster (IC) in this section. TEST the system for normal operation.
U2199 Invalid 'Engine Coolant Temperature' Data DTC U2199 is set when a module receives invalid engine coolant temperature network data from the PCM with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES for a list of all DTCs.
U2472 Unexpected Ignition State GO to Pinpoint Test BF .
U2510 CAN-Invalid Data for Vehicle Security REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
U2511 CAN-Data Mis-Match (Received data does not match expected) REFER to ANTI-THEFT - PASSIVE ANTI-THEFT SYSTEM (PATS) .
U261A CAN Data/Configuration Setup Mismatch The IC and Smart Junction Box (SJB) configuration do not match. If either an IC or SJB was installed, CARRY OUT PMI for the suspect module. REFER to MODULE CONFIGURATION . CLEAR the DTCs. REPEAT the self-test.
SMART JUNCTION BOX (SJB) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
B1352 Ignition Key-In Circuit Failure If the chime sounds with the door ajar and no key in the ignition, GO to Pinpoint Test AN . If the key-in-ignition chime is inoperative, GO to Pinpoint Test AO .
B2479 Park Brake Switch Circuit Short to Ground GO to Pinpoint Test P .
C1125 Brake Fluid Level Sensor Input Circuit Failure GO to Pinpoint Test P .
All other DTCs - REFER to the Diagnostic Trouble Code (DTC) Chart in MULTIFUNCTION ELECTRONIC MODULES .
PCM DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Action
P0457 Evaporative Emission System Leak Detected (Fuel Cap Loose/Off) REFER to the INTRODUCTION - GASOLINE MODELS .
P0460 Fuel Level Sensor A Circuit REFER to the INTRODUCTION - GASOLINE MODELS first. If sent here from the PC/ED manual, GO to Pinpoint Test B .
P0461 Fuel Level Sensor A Circuit Range/Performance REFER to the INTRODUCTION - GASOLINE MODELS first. If sent here from the PC/ED manual, GO to Pinpoint Test B .
P0462 Fuel Level Sensor A Circuit Low REFER to the INTRODUCTION - GASOLINE MODELS first. If sent here from the PC/ED manual, GO to Pinpoint Test B .
P0463 Fuel Level Sensor A Circuit High REFER to the INTRODUCTION - GASOLINE MODELS first. If sent here from the PC/ED manual, GO to Pinpoint Test B .
All other DTCs - REFER to the INTRODUCTION - GASOLINE MODELS .