Transfer Case Shift Motor: Installation
- Apply a small bead of silicone sealant to the transfer case shift motor mating surface.NOTE: New shift motor bracket nuts are loose and are tightened last. Failure to follow the steps in the correct order may result in damage to the component.
- Install the transfer case shift motor and the 3 bolts.
- Tighten to 10 Nm (89 lb-in).
- Install the transfer case shift motor bracket bolt.
- Tighten to 10 Nm (89 lb-in).
- Secure the transfer case shift motor bracket nuts.
- Tighten to 3 Nm (27 lb-in).
- Insert the coil wire pin in the electrical connector and install the inner connector retainer.
NOTE:
After the wire is inserted into the connector, gently pull the wire back to verify the pin is locked inside the connector.