Removal and Installation
NOTE:
On vehicles equipped with Roll Stability Control (RSC®), the ABS module and the Hydraulic Control Unit (HCU) are calibrated to one another. Do not swap ABS modules between RSC®-equipped vehicles.
- If installing a new ABS module, connect the scan tool and upload the configuration information. For additional information, refer to MODULE CONFIGURATION .
- Release the Air Cleaner (ACL) cover retaining clips and disconnect the Mass Air Flow (MAF) sensor electrical connector.
- Loosen the ACL outlet clamp and disconnect the ACL cover from the outlet pipe.
- To install, tighten to 4 Nm (35 lb-in).
- Remove the 3 HCU bracket-to-frame bolts.
- To install, tighten to 20 Nm (177 lb-in).
- Disconnect the ABS module electrical connector.
- Remove the 4 ABS module bolts and the ABS module.
- To install, tighten to 2 Nm (18 lb-in).
- To install, reverse the removal procedure.
- If installing a new ABS module, download the configuration information from the scan tool. For additional information, refer MODULE CONFIGURATION .
- If installing a new ABS module, calibrate the stability control sensor cluster sensor. Connect the scan tool and carry out the IVD Initialization sequence.