LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Expedition RWD >> Repair and Diagnosis >> Electrical >> Starter >> Starting System >> Removal And Installation >> Starter Motor >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Starter Motor: Installation

  1. Position the starter and install the 2 bolts and the stud bolt in 3 stages.
    • Stage 1: Install the 2 starter bolts and the stud bolt finger-tight.
    • Stage 2: Tighten the upper bolt to 25 Nm (18 lb-ft).
    • Stage 3: Tighten the lower bolt and stud bolt to 25 Nm (18 lb-ft).
  2. Position the starter battery ground cable onto the stud and install the nut.
    • Tighten to 25 Nm (18 lb-ft).
  3. Connect the solenoid B-terminal electrical connection and install the nut.
    • Tighten to 12 Nm (106 lb-in).
  4. Connect the solenoid S-terminal electrical connection and install the nut and the starter terminal cover.
    • Tighten to 5 Nm (44 lb-in).
  5. Connect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
scientia non olet · About LEMON Manuals