LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Explorer Base, 2.0 9 >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel System - General Information >> General Procedures >> Fuel Tank Draining >> General Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

General Procedure

WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Before working on or disconnecting any of the fuel tubes or fuel system components, relieve the fuel system pressure to prevent accidental spraying of fuel. Fuel in the fuel system remains under high pressure, even when the engine is not running. Failure to follow this instruction may result in serious personal injury.
WARNING: When handling fuel, always observe fuel handling precautions and be prepared in the event of fuel spillage. Spilled fuel may be ignited by hot vehicle components or other ignition sources. Failure to follow these instructions may result in serious personal injury.
  1. Disconnect the battery ground cable. REFER to BATTERY DISCONNECT .
  2. NOTE: The supplement refueling adapter is located in the luggage compartment.

    Install the supplemental refueling adapter and a length of semi-rigid fuel drain tube into the Easy Fuel ™ (capless) fuel tank filler pipe.

    Fig 1: Installing Supplemental Refueling Adapter
    G07430776Courtesy of FORD MOTOR CO.
  3. Attach the Fuel Storage Tanker to the fuel drain tube and drain as much fuel as possible from the Easy Fuel ™ (capless) fuel tank filler pipe, lowering the fuel level below the fuel tank inlet spout.
  4. NOTE: Some residual fuel may remain in the fuel tank filler pipe. Carefully drain into a suitable container.

    Release the clamp and remove the fuel tank filler pipe hose from the fuel tank.

    Fig 2: Removing Fuel Tank Filler Pipe Hose From Fuel Tank
    G07430777Courtesy of FORD MOTOR CO.
  5. Insert the fuel drain tube into the fuel tank inlet spout, attach the Fuel Storage Tanker and drain as much fuel as possible from the fuel tank.
    Fig 3: Inserting Fuel Drain Tube Into Fuel Tank Inlet Spout
    G07430778Courtesy of FORD MOTOR CO.