TPMS Reset Procedures: Notes

NOTE: Training the sensors is not necessary after a tire rotation on vehicles with the same front and rear tire pressures, but the BCM cannot recognize that the sensor identifiers have been moved to different positions, it only retains the original position the sensors were last trained to.

NOTE: If tire pressure sensor is replaced, it will need to be trained. Do not use the TPMS reset procedure outlined in the Owner's Literature as this procedure will not program new sensors to the module.

When the tire pressure warning light comes on solid and message center displays "LOW TIRE PRESSURE", check the air pressure of all tires and adjust to the specified cold pressure listed on vehicle certification label (found on driver's door or door pillar). Drive the vehicle at 20 mph (32 km/h) for at least 2 minutes. Make sure the warning light goes off.