| B1A56:21 |
Antenna: Signal Amplitude < Minimum |
GO to PINPOINT TEST A
. |
| B1A89:11 |
Satellite Antenna: Circuit Short To Ground |
GO to PINPOINT TEST B
. |
| B1A89:13 |
Satellite Antenna: Circuit Open |
GO to PINPOINT TEST B
. |
| B1D19:49 |
Compact Disc Unit: Internal Electronic Failure |
CLEAR the DTC
. REPEAT the self-test. If DTC
B1D19:49 is retrieved again, INSTALL a new ACM
. Refer to AUDIO CONTROL MODULE (ACM)
. |
| U0155:00 |
Lost Communication With IPC
Control Module: No Subject Type Information |
GO to PINPOINT TEST AB
. |
| U0238:00 |
Lost Communication With Digital Audio Control Module "D": No Sub Type Information |
GO to PINPOINT TEST AE
. |
| U0253:00 |
Lost Communication With Accessory Protocol Interface Module: No Sub Type Information |
GO to PINPOINT TEST AF
. |
| U0256:00 |
Lost Communication With Front Controls Interface Module "A": No Sub Type Information |
GO to PINPOINT TEST AG
. |
| U201A:51 |
Control Module Main Calibration Data: Not Programmed |
- This DTC
sets due to incomplete or incorrect PMI
procedures. CHECK the vehicle service history for recent service actions related to the ACM
.
- If there have been recent service actions with the ACM
, REPEAT/PERFORM the PMI
procedure as directed by the diagnostic scan tool. REFER to
PROGRAMMABLE MODULE INSTALLATION (PMI)
.
- If there have been no recent service actions, INSTALL a new ACM
to correct the failure to retain configuration data. REFER to AUDIO CONTROL MODULE (ACM)
.
|
| U2100:00 |
Initial Configuration Not Complete: No Sub Type Information |
- This DTC
sets due to incomplete or incorrect PMI
procedures. CHECK the vehicle service history for recent service actions related to the ACM
.
- If there have been recent service actions with the ACM
, REPEAT/PERFORM the PMI
procedure as directed by the diagnostic scan tool. REFER to
PROGRAMMABLE MODULE INSTALLATION (PMI)
.
- If there have been no recent service actions, INSTALL a new ACM
to correct the failure to retain configuration data. REFER to AUDIO CONTROL MODULE (ACM)
.
|
| U2101:00 |
Control Module Configuration Incompatible: No Sub Type Information |
- This DTC
sets due to incomplete or incorrect PMI
procedures. CHECK the vehicle service history for recent service actions related to the ACM
.
- If there have been recent service actions with the ACM
, REPEAT/PERFORM the PMI
procedure as directed by the diagnostic scan tool. REFER to
PROGRAMMABLE MODULE INSTALLATION (PMI)
.
- If there have been no recent service actions, INSTALL a new ACM
to correct the failure to retain configuration data. REFER to AUDIO CONTROL MODULE (ACM)
.
|
| U3000:41 |
Control Module: General Checksum Failure |
CLEAR the DTC
. REPEAT the self-test. If DTC
U3000:41 is retrieved again, INSTALL a new ACM
. Refer to AUDIO CONTROL MODULE (ACM)
. |
| U3000:42 |
Control Module: General Memory Failure |
CLEAR the DTC
. REPEAT the self-test. If DTC
U3000:42 is retrieved again, INSTALL a new ACM
. Refer to AUDIO CONTROL MODULE (ACM)
. |
| U3000:96 |
Control Module: Component Internal Failure |
GO to PINPOINT TEST B
. |
| U3003:16 |
Battery Voltage: Circuit Voltage Below Threshold |
GO to PINPOINT TEST AH
. |
| U3003:17 |
Battery Voltage: Circuit Voltage Above Threshold |
GO to PINPOINT TEST AI
. |