Autolock Programming

Autolock Programming

Programming the Autolock Feature Using the Keyless Entry Keypad

1. Place the ignition to the OFF mode and close all vehicle doors.

2. Enter the factory set 5-digit keyless entry keypad code.

3. Press and hold the 3/4 button on the keypad. While holding the 3/4 button, press the 7/8 button.

4. Release the 7/8 button, then release the 3/4 button. The horn chirps once if autolock is disabled or twice (one short chirp followed by a honk) if autolock is enabled.

Programming the Autolock Feature Using the Message Center

1. With all the vehicle doors closed, place the ignition in the ON mode.

2. NOTE: Refer to the Owner's Literature a complete list of the message center menus.

Access the locks menu within the setup menu in the message center.

3. Select autolock and use the left and right arrows to enable or disable the feature.