Toe Adjustment - Front

Toe Adjustment - Front

1. Using alignment equipment and the manufacturer's instructions, measure the front toe.
- Refer to Alignment Specifications in the Specifications for optimal alignment settings.

- If the front toe values are not within specification, go to the next step.

2. Start the engine and center the steering wheel.

3. Turn the engine off and, using a suitable steering wheel holding device, lock the steering wheel in the straight-ahead position.

4. Remove the steering gear bellows clamp(s).





5. Loosen the tie-rod end jam nut(s).





6. NOTE: Do not allow the steering gear bellows to twist while rotating the tie rod.

Rotate the tie rod(s) to achieve the desired toe setting.





7. NOTICE: Make sure to hold the tie-rod end stationary while tightening the jam nut or damage to the boot may occur.

NOTE: Make sure that the toe settings are not disturbed while tightening the jam nuts.

Tighten the tie-rod end jam nut(s) to 103 Nm (76 lb-ft).





8. Install the steering gear bellows clamp(s).