ABS Module Calibration

The ABS module must be configured before it is calibrated. The ABS module must be calibrated if any one of the following components are installed new:

• ABS module
• HCU
• RCM

Calibration is required for the ABS module to learn the "at rest" or "zero position" of the stability control components. If a DTC is set for any stability control component, the DTC must be repaired before carrying out the calibration procedure. The sliding-car icon flashes after clearing any stability control DTCs, indicating that the system is not calibrated.

If a DTC is retrieved after calibration, refer to the ABS Module DTC Chart  .

To calibrate the ABS module, carry out the IVD Initialization sequence. Follow the instructions provided by the scan tool.