LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Ford >> 2012 >> Fusion S, Automatic Trans >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Removal And Installation >> Generator - 2.5L >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Generator - 2.5L: Installation

  1. Position the generator upper air duct and install the 3 screws.
    • Tighten to 4 Nm (35 lb-in).
  2. Working from the top of the vehicle, position the generator and install the generator upper stud hand-tight.
  3. Install the generator lower stud hand-tight.
  4. Install the generator B+ cable and install the generator B+ terminal nut.
    • Tighten to 12 Nm (106 lb-in).
  5. Connect the generator electrical connector.
  6. Position the generator B+ protective cover on the B+ terminal.
  7. Working from under the vehicle, install the lower generator bolt hand-tight.
  8. Working from the top of the vehicle, tighten the 2 generator studs to 24 Nm (18 lb-ft).
  9. Tighten the 2 generator stud nuts to 47 Nm (35 lb-ft).
  10. Tighten the generator bolt to 47 Nm (35 lb-ft).
  11. Push the lower air duct onto the upper air duct until the locking tab is engaged.
  12. Position the RH lower splash shield and install the 6 pushpins.
  13. Position the RH wheel splash shield and install the 4 screws.
    • Tighten to 8 Nm (71 lb-in).
  14. Position the harness locator on the generator stud.
  15. Connect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  16. Rotate the FEAD belt tensioner clockwise and position the accessory drive belt on the pulley.
scientia non olet · About LEMON Manuals