Programming Memory Positions
NOTE:
Memory positions can be stored at any time.
NOTE:
Verify good battery condition before diagnosing the memory seat system. Poor battery condition may interfere with memory seat operation, even if vehicle starting is possible.
- Place the vehicle ignition to ON.
- To set memory position(s), move the memory driver seat, memory exterior mirrors (if equipped), memory adjustable pedals (if equipped) and memory steering column (if equipped) to the preferred position using the appropriate switch(es).
- Press and hold a memory button (1 or 2) until a tone is heard (1.5 seconds). When the tone is heard, the memory programming is complete.
- Repeat the previous steps to program another memory position.
NOTE:
To program the Remote Keyless Entry (RKE) transmitter, refer to
HANDLES, LOCKS, LATCHES AND ENTRY SYSTEMS
.
NOTE:
Input from the driver seat control switch, exterior mirror control switch (if equipped), steering column control switch (if equipped) and adjustable pedal control switch (if equipped) during memory programming will abort the operation.
NOTE:
If other tones or chimes are being produced, the memory save tone will not be heard because it is one of the lowest priorities.