Gearshift Lever: Installation

Position the gearshift lever assembly in the vehicle.
Install the 4 gearshift lever nuts.
- Tighten to 23 Nm (17 lb-ft).
  
  Fig 1: View Of Gearshift Lever Nuts
  Courtesy of FORD MOTOR CO.

NOTE: Make sure the gearshift cables are fully seated into the gearshift lever base or damage may occur.

Fig 2: Locating Gearshift Cables And Gearshift Lever Base

Courtesy of FORD MOTOR CO.

Connect the gearshift cables to the gearshift lever base.
Connect the select cable and the shift cable to the gearshift lever.

Fig 3: Locating Shift Cable And Select Cable
Courtesy of FORD MOTOR CO.
Adjust the gearshift cables. For additional information, refer to MANUAL TRANSAXLE/TRANSMISSION AND CLUTCH - GENERAL INFORMATION .
Install the LH floor console trim panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .

Fig 4: View Of LH Floor Console Trim Panel
Courtesy of FORD MOTOR CO.
Install the floor console finish panel and connect the electrical connectors.
Close the storage compartment door.
Install the gearshift knob.