Vertical Alignment

NOTE: In order to align the Cruise-Control Module (C-CM), which is a radar sensor unit, the vehicle must be in a wheel alignment bay station so that the vehicle is level.

NOTE: Damage to the C-CM bracket may affect correct alignment. When aligning the C-CM, inspect the C-CM bracket for damage and repair as necessary before carrying out the alignment procedure.

Place the vehicle on a wheel alignment bay station.
Remove the C-CM radar sensor unit fascia cover.
Locate the C-CM radar sensor alignment screw.

Fig 1: Locating C-CM Radar Sensor Alignment Screw
Courtesy of FORD MOTOR CO.
Place a combination square level on the face of the C-CM radar sensor unit and check alignment.

Fig 2: Checking Alignment Of C-CM Radar Sensor Unit
Courtesy of FORD MOTOR CO.
Keeping the combination square level on the face of the C-CM radar sensor unit, adjust the pitch of the sensor by using an E5 inverted Torx bit to adjust the screw until the sensor is vertical and level.

Fig 3: Adjusting Pitch Of Sensor Using E5 Inverted Torx® Bit
Courtesy of FORD MOTOR CO.

NOTE: Prior to installing the C-CM radar sensor unit fascia cover, clean and remove any debris on the front or back of the cover.

Install the C-CM radar sensor unit fascia cover.