Lower Intake Manifold: Installation

WARNING: This page is about a different car, the 2007 Lincoln MKX and 2007 Ford Edge. However, it is still accessible from the selected car via links, so may be relevant.

Using new intake manifold and thermostat housing gaskets, install the lower intake manifold and the 10 bolts.
- Tighten in the sequence shown to 10 Nm (89 lb-in).

Fig 1: Installing Lower Intake Manifold Bolts In Sequence

Courtesy of FORD MOTOR CO.

Install the 3 thermostat housing-to-lower intake manifold bolts.
- Tighten to 10 Nm (89 lb-in).
Install the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION AND FILTERING .
Install the fuel rail. For additional information, refer to FUEL CHARGING AND CONTROLS .
Fill and bleed the cooling system. For additional information, refer to ENGINE COOLING .